Vinyl Composition Tile Adhesive (Canada)

Houzz

NEW! TEC Skill Set Vinyl Composition Tile Adhesive is a permanent pressure sensitive latex adhesive for the interior installation of Vinyl Composition Tile (VCT). When used according to directions, TEC Skill Set Vinyl Composition Tile adhesive will bond new tile to old floor coverings. The outstanding features of this adhesive are ease of application, immediate grab, transparent- clear dry film and freeze/thaw stability.
Not for use with solid vinyl tile.

  • Ideal for Vinyl Composition Tile (VCT)
  • Dries clear – allows chalk lines to remain visible during installation
  • Water resistant
  • Strong bond
  • Extended open-time
  • Excellent grab
  • Easy to spread
  • Freeze/thaw stable
  • non-flammable
  • Interior use only
  • Low odor
  • Zero VOC
  • Available in CANADA ONLY
  • 1 gallon plastic pail
Hide reviews

Rate this item

*Name
*City
*Email (will not be published)

Terms and conditions

Description

 

Packaging

1 gallon (3.78 L) plastic pail Product #70-4749-5021


Coverage

See coverage

 


Storage
Store in cool, dry location. Do not store open containers.
 

Shelf Life
Maximum of 18 months from date of manufacture in unopened container.
 

Limitations
excessive moisture or alkali is present. New concrete should be allowed to cure a minimum of 60-90 days prior to installation. Do not use when temperature is below 65°F (18°C). Not recommended for
installation over cushion-backed or unprepared embossed sheetgoods. Freeze/thaw stable to 10°F (-12°C) for a minimum of 5 cycles. If frozen, slowly bring to room temperature and stir before using.
 


Description Test Result
Physical State Thin paste
Color

Off white-wet

Clear-dry

Working time 1-24 hours
VOC/Liter of Material 0 grams (calculated)
Freeze/thaw stability Freeze/thaw stable to 10°F (-12°C) for a minimum of 5 cycles.
If frozen, slowly bring material back to room temperature and stir
before using.
Storage Store in cool, dry location. Do not store open containers.
Shelf live Maximum 18 months from date of manufacture in properly
stored, unopened package.

 

 

Application
For best results, flooring material, room and adhesive should be kept at a minimum of 65°F (18°C) for 48 hours before and 24 hours after installation. Refer to flooring manufacturers installation guidelines for proper application instructions, including trowel size and approximate coverage. TEC Skill Set Vinyl Composition Tile Adhesive has an approximate working time of 1-24 hours, depending on trowel size,
floor porosity, temperature and humidity. Apply adhesive and allow to dry to a clear, transparent film - normally 30-45 minutes before applying tiles. However, tiles may be installed up to 24 hours after
spreading adhesive (dependant on trowel notch selected). Drying time will vary depending upon the temperature and humidity. Check readiness by lightly pressing a finger on adhesive. If there is no transfer to finger when lightly touched, tiles may be set by pressing down firmly. Keep the adhesive film free of dust and dirt. After the floor is set, roll in both directions with a 100 -150 lb. (45-68 kg) roller to
ensure good contact with the adhesive. Protect newly installed VCT with a coat of wax before subjecting to foot traffic. The finished installation must be protected from moisture and/or freezing for a minimum of 24 hours.

 

Clean-up
Remove wet adhesive with a water dampened cloth. Dried adhesive
can be removed with mineral spirits.

 

Technical Service
Available Mon–Fri
8:00am–5:00pm CST:

1-800-TEC-9023
(1-800-832-9023)
Send an email