How to Tile a Shower

6

How to grout a shower

Once you allowed the shower mortar to dry and the tile to sit for the time listed on its packaging, you're ready to move onto the next step: Grouting a shower.

Quick Tip

If grout sticks to the tile, pat it with sponge. Then, take a white nylon scrub pad and scrub the tile. It can remove grout easily.

Once your mortar is dry and your tile is firmly set, remove all of the spacers. Refer to your grout’s packaging for complete mixing and application instructions. Then, use a mixing attachment on a variable-speed drill at low speed to mix the grout according to the instructions on the packaging. If your tiles are stone or terra cotta, wet them before grouting shower tile.

Hands packing in grout with a grout float. 1. Apply Grout Don't be afraid to really pack it into the joints. Many people find it easiest to pack the grout into the joints using the small end of the grout float, rather than the long edge. This method works just fine, but remember to use the long end of the float to scrape off excess grout after the joints are filled.

 

A pair of hands scraping off excess shower grout. If you have excess grout, scoop it up or scrape it off into the bucket. Apply the grout with a grout float, working the grout into the narrow spaces and filling all the joints completely. Work at your own pace and direction that seems natural to you. Holding the grout float at a 45-degree angle to the tile, move it diagonally across the shower floor or ƒif shower wall.

 

 

 

A hand taking a sponge over the freshly grouted and set shower tile. 2. Let grout set. Then clean with sponge Let the grout set according to the instructions on the grout packaging. If you think it's set, touch the grout with your finger. If no grout sticks to your finger, then immediately begin the next phase of grouting. After the grout sets – typically for about 10 minutes – you’ll need to begin cleanup. Slightly dampen a large, small-pore, synthetic sponge. The sponge should not be wet, so make sure you wring it out well. Lightly wipe the sponge across the tile surface, avoiding removing too much grout. Also use the sponge to smooth out the grout joints. If grout pulls out of the joints, you need to allow additional setting time.

 

Two hands wringing out a sponge over a blue bucket. 3. Wring sponge Clean the sponge frequently, and wring out as much water as possible each time. Replace the bucket of cleanup water often. If too much grout is removed, then pack the grout into the joint again and let it set once more.

 

 

 

 

4. Wipe away grout haze Several tiles with a grout haze on them. Wipe away any remaining grout with the sponge and let the grout cure for the required time. Refer to the grout packaging for appropriate cure time. Grout in submerged areas, like showers, take longer to cure. TEC Power Grout RTU cures within 7 days, which means that you can use your shower within a week after the installation is complete. This is a faster cure time than competitors.

 

 

The last step of a shower tile installation is to caulk the tub and shower.

Our diy Expert

Lauren Pagano

Lauren Pagano is a tile and floor installation guru. She has far too much knowledge on obscure topics like grout and floor leveling. Once an over-zealous DIYer, she’s spent the past decade dedicated to tiling, and has great advice on how to perfect your project.

Email Your Question

Leave a Comment

   * Name
   * Email (will not be published)
   Website
Next Step:
How to caulk a tub and shower